Red Hat ENTERPRISE LINUX WS 2.1 - Guia de Instalação descarregar pdf (Página 27)

f) A window will appear:

Additional configuration. Security check. Enable peak

power check (POWCHK). Enable puls power check (PULCHK).

Choose the options if you want to use this security options. Powchk and Pul-

chk require special probes and cortab. If in doubt contact your local Bruker

BioSpin representative, please.

g) Only if you have a sample changer!

Should the Sample Changer control the Lift? (yes/no)

The answer depends on how the air flow is connected, normally you will an-

swer: yes → ENTER

If you have a sample changer, this question appears:

Delay between SX and next command [sec]?

Type in the length of the delay e.g. 10 → ENTER

h) The

nuclei-table appear

Check if the frequency of the nuclei are set correctly. If in doubt click Re-

store then click Save

i) The results of cf appears in a text window. Check this list carefully and

compare the result with an list from an earlier configuration (if available)

click Print and store the paper output with your other spectrometer docu-

mentation, then click OK. These data are saved in:

<TOPSPIN_HOME>/conf/instr/<spect>/uxnmr.info

If during ’cf’ an error message occurs that invites you to do a firmware

update see chapter 6.3

After finishing cf the window config will appear showing a list of configuration

steps. You will be asked for the NMR A

DMINISTRATION PASSWORD several times:

• Continue with expinstall

a) Type in the NMR A

DMINISTRATION PASSWORD and ENTER

b) Click

Next if you either have not modified Bruker BioSpin Parameter files,

AU-programs and Pulse-programs or if you have archived them in a differ-

ent directory. Your individual Parameter files, AU-programs and Pulse-pro-

grams etc. that are named different to the original Bruker BioSpin files will

not be destroyed during the installation.

c) A window appears: Check Installation for Spectrometer → Click Next

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 271 272

Sem comentários

Red Hat ENTERPRISE LINUX WS 2.1 - Guia de Instalação Página 27