Red-hat 8.1 Manual do Utilizador descarregar pdf (Página 81)

Syntax case-exact string

Example nsTaskStatus: Loading entries....

nsT askLog

This entry contains all of the log messages for the task, including both warning and information

messages. New messages are appended to the end of the entry value, so this attribute value grows

larger, without erasing the original contents, by default.

Successful task operations, which have an nsTaskExitCode of 0, are only recorded in the nsTaskLog

attribute. Any non-zero response, which indicates an error, may be recorded in the error log as an error,

but the error message is only recorded in the nsTaskLog attribute. For this reason, use the information

in the nsTaskLog attribute to find out what errors actually occurred.

This attribute value is set by the server and should not be edited.

Parameter Descript ion

Entry DN cn=task_name, cn=task_type, cn=tasks,

cn=config

Valid Values Any string

Default Value

Syntax Case-exact string

Example nsTaskLog: example...

nsT askExitCode

This attribute contains the exit code for the task. This attribute only exists after the task is completed

and any value is only valid if the task is complete. T he result code can be any LDAP exit code, as listed

in Section 5.4, “LDAP Result Codes”, but only a 0 value equals success; any other result code is an

error.

This attribute value is set by the server and should not be edited.

Parameter Descript ion

Entry DN cn=task_name, cn=task_type, cn=tasks,

cn=config

Valid Values

0 (success) to 97

[ ]

Default Value

Syntax Integer

Example nsTaskExitCode: 0

nsT askCurrentIt em

This attribute shows the number of subtask which the task operation has completed, assuming the task

can be broken down into subtasks. If there is only one task, then nsTaskCurrentItem is 0 while the

task is running, and 1 when the task is complete. In this way, the attribute is analogous to a progress

bar. When the nsTaskCurrentItem attribute has the same value as nsTaskTotalItems, then the task

is completed.

This attribute value is set by the server and should not be edited.

Parameter Descript ion

Entry DN cn=task_name, cn=task_type, cn=tasks,

cn=config

Valid Values 0 to the maximum 32 bit integer value

(2147483647)

Default Value

Syntax Integer

Example nsTaskCurrentItem: 148

nsT askTota lIt ems

This attributes shows the total number of subtasks that must be completed for the task operation. When

the nsTaskCurrentItem attribute has the same value as nsTaskTotalItems, then the task is

completed.

This attribute value is set by the server and should not be edited.

Any res p o ns e o ther than 0 is an erro r.[a]

Red Hat Directory Server 8.1 Configuration and Command Reference 81

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 291 292

Comentários a estes Manuais

Sem comentários

Red-hat 8.1 Manual do Utilizador Página 81

Comentários a estes Manuais