Red Hat NETSCAPE ENTREPRISE SERVER 6.1 - INSTALLATION AND MIGRATION GUIDE Guia de Instalação descarregar pdf (Página 23)

5. Verifying Your Installation

With BlueDragon installed, you should now verify that the installation was successful by

running some tests against the BlueDragon server as described in this section.

5.1 Built-in Web Server

To verify that the BlueDragon built-in web server is running, enter the following URL in

a web browser (if you specified a port other than 8080 during installation, use that port

number in the URL):

http://localhost:8080/index.cfm

If the BlueDragon built-in web server is working properly, you’ll see a page similar to the

one in Figure 3, below. See section 8 for more information on using the built-in web

server.

Note that even if you install a web server adapter (discussed in the next section), you will

still use the built-in web server for accessing the BlueDragon administration console

(discussed in Section 6).

Indeed, because the administration console is accessible via the built-in web server,

BlueDragon is configured by default to allow access to the built-in web server only from

the machine on which BlueDragon is installed (localhost). You can change it that, as

discussed in section 6.2, below.

5.2 Web Server Adapter

If you installed a web server adapter, be sure to restart the web server (see section 3.7.2,

below, for Microsoft IIS), then verify the installation by entering the following URL in a

web browser (if your web server is not running on the standard port 80 enter the port

number in the URL):

http://localhost/index.cfm

This URL should return a page similar to the one shown in Figure 3, below.

BlueDragon 6.1 Installation Guide

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

Sem comentários

Red Hat NETSCAPE ENTREPRISE SERVER 6.1 - INSTALLATION AND MIGRATION GUIDE Guia de Instalação Página 23