Red Hat ENTERPRISE VIRTUALIZATION FOR DESKTOPS Manual do Utilizador descarregar pdf (Página 13)

A Principled Technologies sizing guide 13

Red Hat Enterprise Virtualization sizing guide

APPENDIX B – INSTALLING AND TESTING RED HAT ENTERPRISE

VIRTUALIZATION

Figure 12 illustrates the test bed we used to run the Login VSI testing.

Figure 12: Our test bed.

Installing RHEV Hypervisor

We performed the following steps to install RHEV Hypervisor on our system under test. For further information,

refer to the RHEV install documentation located on the RHEV-Hypervisor disk.

Boot to the Red Hat Enterprise Virtualization Hypervisor standalone installation disk.

1. Allow the installation to automatically boot to begin the installation process.

2. Once the installer loads, select Install Hypervisor.

3. Select the proper disk to install RHEV on, and click Continue.

4. Select the disk again, and click Continue.

5. Enter and confirm a new password, and click Install.

6. Once the installation is completed, click Reboot.

Installing RHEV Manager

We performed the following steps to install RHEV Manager, starting from a basic RHEL 6.2 installation. The

following steps require an active Internet connection and a subscription to Red Hat Network’s service.

1. Log in to the RHEV Manager as root.

2. Disable selinux by modifying the /etc/selinux/config file and changing the SELINUX line to

SELINUX=disabled.

3. Sync to local time source.

4. Set up /etc/hosts

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Sem comentários

Red Hat ENTERPRISE VIRTUALIZATION FOR DESKTOPS Manual do Utilizador Página 13