Red Hat NETSCAPE MANAGEMENT SYSTEM 7.0 - AGENT GUIDE Guia de Instalação descarregar pdf (Página 38)

Installing HP SMH remotely on Windows using HP Smart-Update Manager

(HPSUM)

1. To start the deployment, run HPSUM.EXE. The Inventory Progress screen is displayed

while the HP Smart-Update Manager builds an inventory of available updates.

2. The Select Installation Host(s) screen appears when the inventory process is complete.

3. If you want to install HP SMH on the local server, check the Local Host checkbox and click

Next.

4. If you want to install HP SMH on remote server(s):

a. Select the Remote Host or Group checkbox and click Manage Host. The Manage Host

panel is displayed.

b. Click Add Host. Here, you can add a new host(s) by DNS name or IP Address or you

have the option to add a range of IP Addresses.

c. You can also create a group of systems on which you want to install HP SMH by selecting

Manage Groups.

Note: If you chose to Manage Groups, you will need to give the Windows credentials

for each remote server.

5. After selecting the target server, click Next. This will show Discovery Progress while the

system is checked for installed items. Then, the Select Bundle Filter page is displayed.

6. From the Select Bundle Filter page, select the appropriate PSP bundle, addording to the

target server's operating system architecture (either x86 or x64), and check the appropriate

option for the bundle filter. There are three options provided:

I. Allow Non-Bundle Version: Shows other versions of the product that are in the bundle.

This lets you include updates that may be newer than those released in the bundle.

II. Allow Non-Bundle Products: Shows updates for products that are not part of the

bundle. This lets you update other items on your system at the same time as applying

the bundle (as a convenience or because updates in the bundle may depend on them).

III. Force All Bundle Updates: Automatically sets the force flag for updates in the bundle.

This causes the update to install even if it is not necessary as long as the supported

hardware is present and installation conditions are met.

Note: Selecting the bundle filter option is not required when the HP SMH component is

being installed alone.

7. Click Next. This will take you to the Select Items to be installed panel. This panel shows

the components to be installed or displays Installation not needed or Excluded b y filtering.

8. Check the System Management Homepage component and you can pre-configure the HP

SMH component by selecting Configure Now.

Note: If the PSP contains an older version of HP SMH than what is already installed on the

target server, the HP SMH component will be listed under Installation not needed section.

In this case, click Installation Options for HP SMH component and check the For Install

checkbox. The HP SMH component will now be listed under Updates to be Installed.

9. After selecting the HP SMH component, click Install. This will show the installation progress.

10. After installation is finished, the Installation Result panel will be displayed.

11. In the Installation Result panel, you will see two buttons Reboot Now and Exit.

12. If you want to reboot the system, select Reboot Now. If you want to exit the program, select

Exit. This will complete the HP Smart-Update Manager program.

To preconfigure the HP SMH component:

1. From the Welcome to the Configuration Wizard for the HP System Management

Homepage Component page, click Next. The Operating Systems Groups page appears.

38 Installing HP SMH using the HP Smart-Update Manager (HPSUM)

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 71 72

Comentários a estes Manuais

Sem comentários

Red Hat NETSCAPE MANAGEMENT SYSTEM 7.0 - AGENT GUIDE Guia de Instalação Página 38

Comentários a estes Manuais

Manuais e produtos relacionados com Software de gestão de rede Red Hat NETSCAPE MANAGEMENT SYSTEM 7.0 - AGENT GUIDE